HIGHLY EXPERIENCED PROFFESSIONALS
Ready To Help
Hooded vents on the side of buildings can be problematic because sometimes they are recessed in stucco during construction and lose vent opening capacity. They can be cleaned and will work as well as their original installation will allow.
These vents can be problematic because sometimes they are recessed in stucco during construction and lose vent opening capacity. They can be cleaned and will work as well as their original installation will allow.
These louvers were painted shut. The paint dried on the louvers sticking them together and caused a restriction at the end of the vent pipe. We see this a lot. Again these can be cleaned and made to work.
These PVC vents that travel under the slab can trap moisture from the drying process and fill up with condensation and lint. These can be extremely messy and stinky but they can be cleaned up and made to work well.
Most of the time we will need to pull out the dryer to access the vent pipe for cleaning. Again here, we let the lint fall out of the vent pipe as we brushed it before we inserted the vacuum hose to demonstrate how much lint was trapped in the vent pipe.
We always re connect the dryer securely and put it back in place to your satisfaction. We always vacuum the work area before finishing up. Even behind the washing machine.
Do you have a booster fan in your dryer vent system? Some homes, condo and apartment buildings with extremely long vent pipes will have booster fans installed.
Most of the time these are not installed with vent cleaning in mind and there is not much access for cleaning equipment to be used. We will always do the best we can but sometimes there is nothing we can do with booster fans.
This is one of the most common types of dryer vent types that we clean and we do have to get on the roof for part of this service. Cleaning this cap along with brushing out the pipe (above photo) can make your dryer work better and reduce the risk of fire hazard.
This tough blockage is what we usually find in the cap on the roof. It can not be reached by brushing from the bottom only and will stay in place until someone gets on the roof and clears the cap by hand. Sometimes there is a screen in this cap that should have been removed during installation. These screens become 100% blocked with lint in a short amount of time and we will always recommend that these screens be removed.
This is a screen that was removed from a vent cap. It had the vent 100% restricted. We see this a lot. When we go on the roof we check the cap for restrictions like lint buildup and screens left in the cap. We also check to make sure the backdraft flap is operating normally inside the cap.
The pictures shown are of lint buildup that can accumulate in your dryer vents causing dry times to increase and can also result in the following:
- Cause unnecessary wear on your dryer and components
- Increase your energy bill
- Ruin your clothes
- Become a fire hazard
Please note: the lint that is pictured is normally vacuumed out of the vent during the cleaning process and was only let to accumulate on the floor for demonstration purposes. We will never leave a mess in your home.
